| Is your address outside the United States? Click here before ordering to avoid unnecessary delays. |
3 Way Kits
Running, turn signals, & brake light in one unit | HL3Way | 3Way Hyper-Lite with Flashing Brake Light | $98.95
 |
| HL3WayNF | 3Way Hyper-Lite with Non-Flashing Brake Light | $98.95
|
| |
Stop & Running Lights
Dual Function
running & flashing stop lights | Universal | Two 8 LED modules, flasher | $73.95
|
| S16 | One 16 LED module, flasher | $73.95
|
| U2R | Two 16 LED modules, flasher w/ wires and tape on rear | $93.95
|
| U32 | Two 16 LED modules, flasher w/ wires out rear and tape on bottom | $93.95
|
| |
Stop
with flasher | RED
Universal Kit | Two 8 LED modules, flasher | $57.95
|
| One 16 LED module with built in flasher | $55.95
|
| U2R | Two 16 LED modules, flasher w/ wires and tape out rear | $75.95
|
| U32 | Two 16 LED modules, flasher w/ wires out rear and tape on bottom | $75.95
|
| |
Stop or Running Lights
Non-flashing | RED
stop or running lights |
| 8 LED Kit Hyper-Lites without Flasher (2 modules) | $43.95
|
| 16 LED Kit Hyper-Lites without Flasher (1 module) | $43.95
|
| 16 LED Kit Hyper-Lites without Flasher (2 modules) | $65.95
|
AMBER
Running lights |
| 8 LED Kit Hyper-Lites without Flasher (2 modules) | $43.95
|
| 16 LED Kit Hyper-Lites without Flasher (2 modules) | $65.95
|
| |
| 2 Way Turn Signals | 2 Way Turn Signals | 4 LEDs each side of the module (2 modules) | $45.00
|
| 2 Way Turn Signals | 2 Way Turn Signals | 8 LEDs each side of the module (2 modules) | $65.95
|
| Accessories | License Plate Bracket | (Fits all 7 7/8" & smaller plates) | $10.50
|
| Switch Modules | 1 switch | $25.00
|
| Brake, Running Lights, & Turn Signals | 3 Way Kits
The dimensions are approximately 3" x .5" x .5"
There are 2 different kits.
- The standard kit consists of 2 modules with 16 Light Emitting Diodes (LED) in each module.
- Each module is wired independently for BRAKE LIGHTS, RUNNING LIGHTS, AND TURN SIGNALS.
- The Brake lights and Running lights are contained in one half of the module, and are RED when engaged.
- The Turn Signals are in the second half of the module, and are AMBER when turned on.
- Same as above EXCEPT it also flashes when the brake lights are activated.
- The 3 WAY Hyper-Lite kit will adapt to most vehicles with 12 volt electrical system.
- The Hyper-Lite modules mount with 2 sided tape. The mounting surface for the 3 WAY modules must be a vertical side or rear surface, or a top or bottom surface on the rear of the vehicle.
|
|
| Stop & Running Lights |
The latest innovation is the Dual Function flasher.
- The Dual Function turns Hyper-Lites into running lights (at a reduced intensity - about 40%) until the brakes are applied. The LEDs then flash at their normal (very bright) intensity.
- Dual Function flashers are also selectable between continuous flasher mode or 5 second mode which flashes for 5 seconds then goes solid.
- The flasher dimensions are approximately 1.5" x .5" x .5"
|
| Stop Lights | The Universal Hyper-Lite kit will adapt to most motorcycles with 12 volt electrical system. The Hyper-Lite modules mount with 2 sided tape. The mounting surface for the Hyper-Lite modules must be a vertical side surface or a top or bottom surface on the rear of the motorcycle.
For the few motorcycles which do not have a suitable mounting surface we offer a Universal license plate mounting bracket
There are 2 different kits.
- The standard Universal kit consists of 2 modules with 8 Light Emitting Diodes (LED) in each module and one flasher module.
- The S-16 kit is a single module with 16 LED and a build in flasher.
All Hyper-Lite kits now come with selectable flashers.
At time of installation you can choose between continuous flasher mode or 5 second mode which flashes for 5 seconds then goes solid bright. Some states & municipalities do not allow continuous flashing stop lights |
| Stop or Running lights non-flashing | These are 8, or 16 LED units in Red.
The Stop lights are about 1/3 brighter and are not recommended to be used for running lights as they are too bright to be constantly on. |
| Running lights non-flashing | These are 8, or 16 LED units in Amber |
2 Way Turn Signals
(auxiliary)
photos |
- Simple to install
- Wires directly to your turn signal
- Can be seen front, back, and blind spots
- These are not made to replace your turn signals, but as an enhancement
- Note: If the outside edge of your mirrors (or area where you are mounting) is less than 1/2" wide or has a large curvature they probably won't work
|
| Switch Modules |
- Simple to install
- These will handle up to 5 amps continuous (or as much as you want by adding a relay)
- Waterproof
- Mount almost anywhere with our super-stick double sided tape
- Black heavy duty case
- Compact; switch modules are 1½" x 1" x 1"
|
