FJR 1300 Passenger Backrest Installation 1. Remove Rider and Passenger Seats. 2. Remove the 4 allen bolts 8mm x 30mm and (1) 8mm button head allen or phillips holding rear rack to fairing. 3. Remove stock rack. 4. Attach new backrest to new rack using (2) 1/4-20 x 5/8" flat head allens. (Backrest mounts underneath rack.) 5. Mount new rack brackets in square fairing cut-outs using (2) 8mm x 30mm allen bolts (stock). Use stock bushings from stock rack to shorten bolt length (if preferred). Brackets should face the rear with bracket cut-outs to the inside. 6. Loosely tighten. Set rack on brackets with 3/4" long bushing under rack at rear mounting point. 7. Attach (2) front brackets using 1/4-20 x 3/4" flat head allen's and self locking nuts. 8. Attach rear mounting point with 8mm x 50mm button head allen. ( screw goes thru rack, backrest, and bushing) 9. Finish tightening all 5 mounting points. Install backrest pad with (4) 1/4-20 x 1" allens. (Be careful not to cross thread tee nuts.) 10. Backrest angle can be changed a little by lengthening or shortening the bushing. (If desired) We Use For Credit Card Orders